Distributor Products

Distributor Raise Kit assembled — Assembled distributor raise kit

Distributor Raise Kit components — Kit components

Kit Details

In a few of the PME Intake Adapter Plates, a distributor clearance problem occurs. This happens more often with the thicker style adapter plates. When this occurs, PME provides a kit to raise the distributor 2½″ to clear the water inlet of the intake manifold.

The kit comes complete with instructions. You will need to measure in thousandths and have the ability to press the pieces together. The kit includes an aluminum housing, a soft steel sleeve that presses to the distributor (after you remove the gear and upper pieces), a steel piece with an internal and external component, two set screws, and an O-ring.

Measuring the distributor before you begin is one of the most important steps in this assembly. If the distributor is not exactly Ford length, the excess must be removed — otherwise the distributor will stick up out of the block when you are done and you will have to start over.

DK-01 — Distributor Raise Kit

Part No. DK-01

For raising a 351W, 351C, 351M/400M, or 429/460 Ford distributor.

$154.43

DK-03 — Distributor Convert & Raise Kit

Part No. DK-03

For converting a 351W, 351C, 351M/400M, or 429/460 distributor and placing it into a 302 block while raising it 2½″.

$161.22